Blog week 47

This week has been a mental recovery from making my MIT maker portfolio. There is no combination of the roughly 2 million English words that can describe how exhausted I was.

I decided to work on the baby mill even though the shop has no purpose for it, I think it is really cool. So my first step was to move it onto a workbench. So I got the rolly thingy to move it but I bumped the engine, spilling gasoline everywhere. Auto tech told us to just let it evaporate so we got a fan running and used compressed air to blow the smell out of the shop.

On the mill I disassembled the X-axis and the Y-axis and cleaned them. They weren’t as dirty as the axis on the lathe, however there was still some gunk. I then re-assembled them and realized how easy it would be to switch the mill to use ball screws.

I wanted to test backlash, so I took the magnet base that came with the mill and tried to set up a dial indicator with it. The diameters for the mounting didn’t line up, so I used some locking collars to bridge the gap between the diameters of the little dial mount, to the magnet base.

When working on the X and Y axis of the mill, I didn’t improve the performance of the mill that much, however I learned a ton about how the mill functions. Understanding how linear axis are assembled and adjusted I going to be very useful in my future work on the gripper.

Next I did the Z-axis, which is a little different because it uses a rack and pinion and a pneumatic thingy ma-jig to move. This axis was actually messed up and I did improve it’s performance. When working on this I realized that I wanted to add an automatic tool-changer to the drawbar. I don’t want to deal with compressed air motor so I started looking at our bigish motors to make a toolchanger with.

I found a motor that I think will work, however all the important information on the motor was scratched off, so I tested it with the power-supply. It drew 2.4 Amps and 24 volts so I am going to try and connect it to the 17 mm socket that the drawbar uses and see if it has enough torque.

I don’t know how I would measure the torque of the motor, however the target range I am looking for, for this application, is 15 – 60 foot pounds.

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *